The Tisch 1-canister Sampler takes air from the inlet on the pump and injects it into the canisters at a constant flow rate for a preset time. The excess air is released through the bypass exhaust. The constant flow rate and elapsed time allow the operator to compute the volume of the integrated air samples. The samples are pumped through a Stainless Steel, Teflon diaphragm, 12 V.D.C. pump, which develop sufficient pressure to control the flow with a Porter regulator. The pump also samples the air at a flow rate (5 L/min) to keep any long sampling line flushed. A small, constant flow of sampled air is pumped into the sample canisters. The sampler will operate on 12 volts d. c. through a molex plug on back of sampler. The pointed end of the plug is positive (+) and the flat end is negative (-), and draws 5 amps. (ALWAYS USE A 5 AMP FUSE INLINE ON THIS 12V.D.C. INPUT) The a/c cord will take an input of 100-240 V.A.C. at 2 amps.

 

Meets all requirements of EPA Compendium Method TO-14/TO-15

Operation Instructions in menu format on LCD touch screen panel. Unique   ease of programming directly on touch screen

Remote starting from site data logger

Operation from 100-240v AC 50/60 HZ or 12 VDC battery or auxiliary   power from vehicle or solar panel

Bench mount or 19” rack mount

Condensation trap

Flow rate 1-300 ml/min

Stainless steel vacuum and pressure gauges for direct read of canister

3-way valve allows sampler purge and flow adjust directly before   canister port allowing the flow circuit to be removed from sample line 6   liter canister can be filled to 10 PSI in less than 40 minutes

Additional channels available up to 7